HD PVR 2 SOFTWARE VS WINTV PC
I don't have WinTV 7 installed on the PC I'm using now and I don't use WinTV 7 often, but I don't recall a way to set specific bit rates. Does WinTV limit a 8k bitrate? I can't seem to get it over 8k and i don't see any settings to control quality of the recordings. It's no where near as nice as using the Hauppauge Capture software. I have to say that i'm kind of disappointed in the quality of WinTV recorded footage.
HD PVR 2 SOFTWARE VS WINTV TV
I think i finally got it after trying every brand even close to the model of my TV box. Here is a list of cable boxes and DVRs used by Time Warner. Was your Time Warner Samsung model included in the list? If not, maybe the codes for another box will work. It looks like here is a list of cable boxes to choose from at some point in the process. I reviewed the documentation for the IR blaster setup in WinTV 7. It looks like here is a list of cable boxes or manufacturers to choose from at some point in the process. I selected one of the other cable boxes used by my provider and that worked. Some cable providers, maybe most, use the same remote with all their boxes.
HD PVR 2 SOFTWARE VS WINTV SOFTWARE
I found another way to approach the problem rather than teaching the software manually. It was not a fun thing to do and did not work very well. One thing I tried was "teaching" Windows Media Center the remote codes because I did not find my cable box in their list of cable boxes with known remote codes. I did set up the MCE IR blaster for Windows Media Center to use with a different Hauppauge capture device. I already had 2 other ways to change channels at my disposal, one of which is an MCE IR blaster. I have to confess that I never set up my Colossus' IR blaster. I added numbers 1, 2, 3 like 5 times now and it still doesn't put them into the TV box. If i click on that channel it will load to it, but when it puts in the numbers to the TV box. I add them and it says that they added them, but when i try to go to a channel with one of them numbers it doesn't work. I managed to get Power and enter to work, but the numbers on my remote just don't seem to want to work.Įdit: I got all the numbers working besides 1, 2 and 3 I even tried to program it myself, but it just kept telling me "LearnKey(1) failed" Does anyone have a video for setting it up besides the one on the Hauppauge YouTube channel? I spent like 2 hours last night trying to get the IR blaster working WinTV with no luck. Now i just have to figure out this IR blaster that will won't work for the life of me. It turned itself back on some how even though i turned it off till next reboot. I think it might have just been my Anti Virus. I was just using the Hauppauge Capture software.